Owner`s manual

- 9 -
CHAPTER 2: Basics
Installing Your Illumina SR
Please read the following instructions thoroughly and consult with an expert before installing your Il-
lumina.Thextureshouldalwaysbelocatedaboveyourdisplayinawell-ventilatedspaceandshould
not be touching any surfaces once suspended. Locate the unit away from areas of high humidity and/
or water and salt spray.
Assembling the Suspension Kit
Locate the rubber O-rings and loop them over each of the threaded ends of the Cable Clamps.
TakeeachCableClampandinstalltotheIlluminaxturebythreadingtheboltsthroughtheadjustable
suspensionbridgesfoundinthecenterchannelofthexture.Hand-tightenonly.
Cables
Begin by noting the two different ends of the steel ca-
bles. One end will have steel bolt. This is the stopper
end and it goes anchor-side. The other will be a bare
line. This end threads through the cable clamp and is
xture-side.
At this point, do not attempt to trim/shorten or crimp
any of the cables.