Installation manual

5.0 Model 1000 and 1010 Description
5.1 Model 1000 and 1010
The Model 1000 provides water at 2-temperatures , dispensed from two spigots,
“hot” and “cold”. The assembly drawing is shown in Figure 8. Water flows from the fil-
ter system into the top tank which is also the cold water tank. This tank then feeds the
hot tank by gravity. The level in the cold water tank is controlled by a valve and float
ball assembly in the tank. The Model 1010 provides only cold & room temperature
water. Both models are available with reverse osmosis (R) or standard filter (F) versions.
5.2 Position Cooler - Same procedure as for Model 2000 (see3.2)
5.3 Water Connections
Fig. 9 shows the back of the 1000 cooler which has the same water connec-
tions as the 2000 Model. Note that there are separate hot and cold power switches
to turn on for operation. There is no front control panel in the 1000 model. There
are three LED indicators which included.
• Hot power on
• Cold power on
• Heating is in Progress
Figure 8 Model 1000 Assembly
Top Cover
Hot Water Tank
Main Water Tank Cover
Main and
Cold Water Tank
Hydraulic Type
Floating Valve
Indicating Panel
Cold-Water Tap
Hot-Water Tap
(With Safety Device)
For PWC1010
Room Temp Tap
Drip Tray
Filter Assembly Area
– 12 –