Specifications

Chapter 2 - Product Installation
T A B L E 9 T H E D E S C R I P T I O N S O F T H E ST A T I C I P A D D R E S S PA R A M E T E R S
Parameter Description
Encapsulation
Select the encapsulation type from the dropdown list
Static IP
Address Enter the static IP address
IP Subnet Mask
Enter the IP subnet mask
Gateway
Enter the gateway address
NAT
Select whether NAT is enabled or disabled
Default Route Select whether this PVC will be the default route for the Internet
data
Dynamic Route
Select the RIP type and direction form the dropdown lists
Multicast
Select the multicast protocol to be used from the dropdown list
Note: The parameters listed in Table 9 should be provided by the ISP.
PPPoE/ PPPoA
Figure 11 shows the PPPoE/PPPA parameters on the web configuration page
and Table 10 gives the parameter descriptions.
Proprietary Information of ZTE CORPORATION 21