Specifications









    

1. Connectthe VXR-7000’s TX antenna porttoa
wameter anddummy load (theduplexer must
not beconnectedatthispoint). Connect any
VertexStandard microphonetothe
MIC
jack,
and place the
BASE/REPEATER
switch in the
“”position.SelectChannel1foralignment
purposes.
2. Press and hold in the
ACCESSORY
switch for
twoseconds to enter the adjustment mode. The
channelnumberwillbegintoblink.
3. Pressandholdinthe
PTT
keyonthemicrophone.
Thedisplaywillindicate“Po”whiletransmiing.
Observe thepower output as indicated on the
wameter.
4. Keeptheholdinginthe
PTT
key,pressthe

(UP:
increment)or

(DOWN:decrement) buon(to
therightofthechanneldisplay)repeatedlytoad-
justtheTXoutputpowerto40Was(orless).

5. Keeptheholdinginthe
PTT
key,pressandhold
inthe
ACCESSORY
buonfor atleast twosec-
ondstosavethenewseingandexittothenor-
maloperation.
6. Releasethe
PTT
key.
7. Repeatsteps 2. through6. (above)foranyother
channels(2through16)iftheyaretobeused.
8. Re-test eachchannelinthe normal operating
mode to confirmtheproper power output. You
maynowdisconnectalltestequipment.
9. Theduplexermaynowbeinstalled.
Theabove procedure shouldonly be performedby
yourAuthorizedVertexStandardDealeroraquali-
edradiotechnician,inordertoensureaccuratecal-
ibration.PleaseconsultwithyourAuthorizedVertex
StandardDealerforassistancewithprocurementof
asuitableduplexer.