Specifications

VXA-150 P
RO
V
O
PERA
TING
M
ANUAL
11
1 2 3
4
7
SPL
8
BEEP
SKIP
MW
DW
ANL
0
9
5
6
121.5
To AC line outlet
Lift up the
rubber cover
Transceiver must
be switched off
r If using a charger other than the NC-72, or if us-
ing a battery pack other than the FNB-64, follow
the appropriate instructions provided with the
charger/battery. Contact your Dealer if you have
any doubts about the appropriateness of the par-
ticular charger or battery pack you intend to use.
r The optional FNB-V57 high-capac-
ity battery can not be charged using
the NC-72; please use the optional
VAC-400 or NC-76.
BEFORE YOU BEGIN
Battery Charging
It is necessary to fully charge the Ni-Cd battery be-
fore its first use. Follow these procedures:
¦ Install the supplied FNB-64 Ni-Cd battery pack
onto the transceiver. Ensure that the transceiver
is switched off.
¦ Lift up the rubber cover to expose the EXT DC
jack. Plug the cable plug from the NC-72 charger
into this jack.
¦ Plug the NC-72 into the AC line outlet.
¦ Allow a minimum of 15 hours for the FNB-64
to reach full charge. Leave the transceiver
switched off this entire period.
¦ Unplug the cable from the EXT DC jack. Re-
place the rubber cover to protect the jack. Switch
on the transceiver and begin operation.
Important Notes:
r The NC-72 is not designed to power the trans-
ceiver for operation (reception or transmission).
r Do not leave the charger connected to the trans-
ceiver for continuous periods in excess of 24
hours. Long term overcharging can degrade the
Ni-Cd battery pack and significantly shorten its
useful life.