Specifications

VX-1400 OPERATING MANUAL40
The VX-1400 allows the user or dispatcher to store the frequency and operating mode
into the desired Memory Bank.
 Press the
[

]
/
[

]
button to recall the Memory
Bank which wants to store the data.
 Press the
[
MW
]
button
(the [
PROGRAMMABLE
]
button which assigned “Memory Write” function); on the LCD you will see a blink-
ing memory channel number.
 Press the
[

]
/
[

]
button to select the Memory channel onto which you wish to store
new frequency information. If you select a chan-
nel on which data is already stored, entering new
data will cause you to overwrite the data previ-
ously stored.
 Press the
[
MW
]
button, then enter seven digits (from 10 MHz digit to 10 Hz digit) of
the desired receiving frequency by pressing the
[

]
/
[

]
(move the cursor) and the
[

]
/
[

]
(se-
lect number) buttons.
 Press the
[
MW
]
button, then press the
[

]
/
[

]
button to select the desired operating
mode. Available operating modes are “J3E-
USB”, “J3E-LSB”, “J2B-USB”, “A1A”, and
“A3E”.
 Press the
[
MW
]
button. If your radio assign the CLAR function to the Programmable
Function (P0 ~ P4) buttons, set the clarifier off-
set frequency (up to ±1.000 kHz) by pressing
the
[

]
/
[

]
(move the cursor) and the
[

]
/
[

]
(select number) buttons. Otherwise, skip to the next step.
 Press the
[
MW
]
button, then enter seven digits (from 10 MHz digit to 10 Hz digit) of
the desired transmit frequency by a same procedures as entering the receiving fre-
quency (only if you wish to store independent
transmit and receive frequencies on the same
channel). Otherwise, skip to the next step.
 If you wish to append an Alpha/numeric “Tag” to this channel, press the
[
MW
]
but-
ton, then enter the desired name “Tag” (up 14 digits) by pressing the
[

]
/
[

]
(move
the cursor) and the
[

]
/
[

]
(select character/
number) buttons. Otherwise, skip to the next
step.
 Press the
[
MW
]
button, then press the
[

]
/
[

]
button to select the desired TX output power.
Available selections are “HIGH”, “MID”, and
“LOW”.
MEMORY CHANNEL STORAGE