Security Camera User Manual

VerteX RTH Series H.8 and H.16 Series

 Select the channel at {Menu} Æ {Setup} Æ {Recording} Æ {Alarm Action} Æ {PTZ Preset}.

 Select {Preset Action}.

[Figure 5-36. Preset Action Setup Window]

The user can set every channel with the same duration by pressing the Select button

after moving the focus on the top of {Preset} column.

Preset are available up to 1 ~ 8.

C) E-mail

When an alarm or an event occurs, emails will be sent to the specified email address. The text of E-mail can be

shown at {Menu} Æ {Miscellaneous} Æ {Log Viewer}.

A. Motion

Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. The e-mail will be sent if the motion is

detected.

B. Sensor

Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. The e-mail will be sent if the sensor is

detected. Select {On} / {Off}.

D) Event Spot

Displays the video on the TV monitor connected to the spot port on the rear side of the system in case of an

alarm or an event.

A. Motion

Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. Display the video on the Spot TV

monitor if the motion is detected. Select {On} / {Off}.

B. Sensor

Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. Display the video on the Spot TV

monitor if the sensor is detected. Select {On} / {Off}.

E) Relay Output

In case an alarm or an event occurs, all external alarm devices connected to the relay port will be triggered.

Depending on the models, up to 1-4 relays are supported.

A. Motion

Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. Relay the external device if the motion

is detected. Select {On} / {Off}.

B. Sensor

Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. Relay the external device if the sensor

is detected. Select {On} / {Off}.

C. Relay Type

Select the relay type; NC/NO.