Security Camera User Manual

VerteX RTH Series H.8 and H.16 Series
48
sensors can be set. When a signal of an external sensor is detected, the video of the corresponding channel
will be recorded.
 In the sensor selection window, select a external sensor channel.
 Select the sensor type.
NC(Normal Close) : Normally closed; opens when a signal is received
NO(Normal Open) : Normally open; closes when a signal is received
C) Post-Event
Set up the time of the recording duration after an event is taken place. Select between 5 – 300 seconds.
[Figure 5-35. Motion Setup]
 Select the recording duration using the arrow keys and the Select button.
The recording duration unit is a second. Record the image for the duration time set at
every event detected.
The user can set every channel with the same duration by pressing the Select button
after moving the focus on the top of {Post} column.
6-2-5. Alarm Action
This feature is used to generate alarms through the buzzer, mail, spot monitor, Relay or TTL in case of an event.
A) Alarm
A. Motion
Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. The alarm goes off if the motion is
detected. Select {On} / {Off}.
B. Sensor
Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. The alarm goes off if the sensor is
detected. Select {On} / {Off}.
B) PTZ Preset
When an event occurs, the PTZ camera will be preset.
A. Sensor
Move to {Menu} Æ {Setup} Æ {Recording} Æ {Recording} Æ {Mode}. PTZ camera goes to the pre-set
position if the sensor is detected. Select {On} / {Off}.
B. Preset Action