User manual

User Manual Rayocomp PS 1000 Polar Page 2-50
2.7.3 How can I carry out an allergen desensitisation?
The Rayocomp PS 1000 Polar supports allergen tests and desensitisation
extraordinarily well. A protection cup can be found on the front left side of the
Rayocomp, in which you can place the tested allergens in ampoules, without
letting them get in touch with the oscillation pattern of other allergens or those
of the patient, which would certainly falsify them.
Select the Bio-resonance
according to Paul
Schmidt in the main
menu, then press the key
Harmonization and
finally the key Allergen
desensitisation before
working with the
required functions.
The picture you can see
on the right appears.
Now you can enter the
desensitisation time. It is
pre-set to 15 minutes.
Note, that desensitisation
may take up to one hour, depending on the circumstances. Place the allergens
required for desensitisation into the protection cup.
With the key Start
desensitisation, you
change over to the
harmonizing window:
The Interrupt
key allows
you to make a pause
during harmonization
(i.e. to allow your patient
to visit the bathroom).
Desensitisations are
performed with the
polariser set to +/- as a
standard.
The allergens are desensitised, if you switch over the polariser to N and the
sensor verges into a rotation. If the sensor does not show a rotating motion,
please switch over to +/- again and repeat the test some time later.