User manual

User Manual Rayocomp PS 1000 Polar Page 2-19
As an example, the geopathy test is explained in the following.
Currently, the
interferences shown
in the display (see
caption 1) are in the
display mode (see
caption 2). In the
display mode, you
can look at the
interference values
and their resonances
with the help of the
navigation keys
without setting every
single value first. This
function is
particularly useful if
you want to look at a
previous test and its
results from the patient history.
2
1
3
5
4
Basically, you can print the interference values and their resonances displayed
in the window at any time (see caption 3) or use them for harmonization (see
caption 4).
With the key Start (see caption 5), you change over from the display to the test
mode. When the Start key is pressed, the interferences can be seen on the right
side, and also the four polariser keys. The basic set up of the polariser is always
N = neutral, which means, without polarisation.
In caption 6, the
current state of the
associated resonance
is displayed. In the
display mode, all
resonances are set to
n.t., which means not
tested. If a new
resonance is being
tested, the resonance
property is set to i.O.
at first, which means in
order = treatment
unnecessary.
6