User manual

User Manual Rayocomp PS 1000 Polar Page 2-17
Now integrate the patient in the allergen test. Instead of the hand detector,
connect an allergen detector and let your patient hold it in his left hand. The
patient is still connected with the foot detectors and the right hand detector.
Now the patient touches the ampoule filled with the substance, which is going
to be tested. If you only want to test a few ampoules, you can also place the
ampoule into the protection cup of the device. In this case, the patient is
connected with the hand as well as the foot detectors.
Is the present intolerance strong or weak?
Now test with the sensor to find out, whether you achieve a rotation (left or
right motion) or a linear movement. If the sensor is rotating, the substance
cannot destabilise the corresponding field of the organism, in other words, the
body has no problems with this substance.
If, however, the achieved motion is linear, this patient is suffering from an
intolerance of the substance. If it is irrelevant for you, whether the blockade is
strong or weak, you now press the button on the sensor in the direction of the
spring wire. The device will store an N - resonance. Then press the button of
the sensor to the right, and the next ampoule can be tested.
If you want to know exactly, which polarisation is most suitable for helping the
organism, or if you want to find out, whether the disturbance is strong or weak,
then press the button down after having tested a linear movement on N. Now
the polariser is switched over to polarisation +/-. If the sensor already starts to
rotate, the intolerance is not very strong. In this case, press the button of the
sensor to the right, and the next ampoule can be tested. If the linear movement
continues when set to +/- polarisation however, the intolerance is stronger.
Press the button down again and test, whether the + polarisation, which is now
set, leads to a rotation. Rotation means, that the + polarisation is most suitable
for harmonization. If the sensor still doesn’t start rotating, press down the
button of the sensor once more. Now you will see, that there is a rotation with
the – polarisation.
If you need further information concerning this test, you will find it in the
answer to question 2.2.1.
If you want to desensitise the tested allergens at once, please press the key
Harmonize (and also regard question 2.6.3).