User manual

User Manual Rayocomp PS 1000 Polar Page 2-16
2.2.6 How do I test an individual allergen?
Beside the global test set, with which you can test a total of 70 so-called
collection ampoules (see question 2.2.5), you also have the possibility of
testing single substances on their intolerability.
After you have pressed the
key Bio-resonance
according to Paul
Schmidt in the main
menu, please activate the
key Test. Then press the
key Individual allergen
test on the left side. The
picture you can see on the
right appears.
A screen page becomes visible, which shows all necessary steps for preparing
the allergen test.
Please connect the patient with hand and foot detectors. Now, please test,
whether the five set interferences cause a rotation of the sensor. In this case,
the fields corresponding with the interferences are stable, and you can use
them to test the effect of a substance brought into the oscillation circle of the
device (allergen) and find out, whether it weakens the body. The last mentioned
would show in a linear motion of the sensor.
You see, that an important pre-condition for a correct test is the initial test on
rotation with these five transfer values. If no rotation is achieved, the transfer
values must be harmonised first. To do this, please switch the polariser to +/- .
Wait a couple of minutes, then test them on rotation again, with the switch of
the polariser in N position. An individual allergen test can only be safely carried
out, if the transfer values achieve a rotation with the polariser switched to N.