User manual

User Manual Rayocomp PS 1000 Polar Page 2-14
The following monitor page appears:
In the window, all the ampoules contained in the global test set appear.
Now integrate the patient
in the allergen test.
Instead of the hand
detector, connect an
allergen detector and let
your patient hold it in his
left hand. The patient is
still connected with the
foot detectors and the
right hand detector. The
patient touches the first
ampoule in the global test
set, one of four pre-test
ampoules, to ensure, that
he shows no intolerances
against the substances
used in the ampoules for
preservation.
After the patient has touched the first ampoule with the allergen detector,
please check on the reaction of the sensor (rotation or linear movement). Please
test all four ampoules in this way. If you achieve a linear motion with one of the
ampoules, desensitising is required first. In this case, press the key Harmonize
and place the ampoule, which has prompted the linear motion, into the
protection cup attached on the left side. Desensitise (also take a look at the
answer to question 2.6.3.). After desensitising, close the corresponding window
to return to the 70s allergen test, which can now be carried out without
problems, thanks to the optimal preparation.
Now test all ampoules from G5 to G70 by letting the patient touch each single
ampoule with the allergen detector, and watch out for a rotation or a linear
movement. The device saves the resonances. If you have a file of your patient in
the patient administration, the device will store the results there, to be called
up and re-tested at any time later on.