User manual

User Manual Rayocomp PS 1000 Polar Page 2-13
Testing the Global Test Set:
After you have pressed the
key Bio-resonance
according to Paul
Schmidt in the main
menu, please activate the
key Test. Then press the
key 70s allergen test
on
the left side. The picture
you can see on the right
appears.
A monitor page becomes visible, which shows all necessary steps for preparing
the allergen test.
After having connected the patient with hand and foot detectors, please test the
five set interferences on a rotation of the sensor. In this case, the fields
corresponding with the interferences are stable, and you can use them to test
the effect of a substance brought into the oscillation circle of the device
(allergen) and find out, whether it weakens the body. The last mentioned would
show in a linear motion of the sensor.
You see, that an important pre-condition for a correct test is the initial test on
rotation with these five transfer values. If the rotation cannot be measured, the
transfer values must be harmonised first. To do this, please switch the polariser
to +/- . Wait a couple of minutes, then test the on rotation again, with the
switch of the polariser in N position. The 70s allergen test can only be safely
carried out, if the transfer values achieve a rotation with the polariser switched
to N.
As soon as the preparations for the allergen test have been completed, please
press the key Start of the 70s allergen test
.