User manual

User Manual Rayocomp PS 1000 Polar Page 2-8
The monitor changes to display the following page:
Now test with the sensor
to find out, whether you
achieve a rotation (left or
right motion) or a linear
movement. A rotation
means, that the field in
the organism linked to the
interference is stable and
therefore does not require
treatment. If, however, the
achieved motion is linear,
this patient suffers from
an energetic blockade. If it
is irrelevant, whether the
blockade is strong or
weak, you now press the
button on the sensor in
the direction of the spring wire. The device will store an N - resonance. Then
press the button of the sensor to the right, and the next interference can be
tested.
If you want to know exactly, which polarisation is most suitable for helping the
organism, or if you want to find out, whether the disturbance is strong or weak,
then press the button down after having tested a linear movement on N. Now
the polariser is switched over to polarisation +/-. If the sensor is now already
performing a rotation, the disturbance is not very strong. In this case, press the
button of the sensor to the right, and the next interference can be tested. If the
linear movement continues when set to +/- polarisation however, the
disturbance is stronger. Press the button down again and test, whether the +
polarisation, which is now set, leads to a rotation. Rotation means, that the +
polarisation is most suitable for harmonization. If still no rotation could be
achieved, press down the button of the sensor once more. Now you will see,
that there is a rotation on the – polarisation.
In this way, you must test all the interferences offered to you. If you are unsure,
whether you have skipped an interference by mistake, you can press the button
of the sensor to the left, and you return to the previous interference. If you
need further information concerning this test, you will find it in the answer to
question 2.2.1.
Information on refining: If you want to work out a detected resonance
value more concretely (precisely), please press the key Refining. This
allows you to use smaller step lengths to find the exact value.