User manual

User Manual Rayocomp PS 1000 Polar Page 2-7
2.2.3 How do I carry out the most successful patient test, the range value
test?
The range value test is the perfect method for testing very complex symptoms
or disorders, which are particularly difficult to treat.
The range value test concretely begins with the start value. This is followed by
testing each interference on resonance in steps of 00.50.
As a result, the range value test is a compilation of all those resonances the
body needs for regulation.
If you test the so found resonances again after several harmonizing sessions,
you will discover, that only parts of the interferences need further harmonising.
If this process is repeated several times, at the end only a few really stubborn
resonances will remain, which is very helpful for stating an excellent diagnosis.
With the range value test and the harmonization resulting from it, you can also
build up a really good prevention.
After you have pressed
the key Bio-resonance
according to Paul
Schmidt in the main
menu, please activate
the key Test. Then press
the key Test with range
values on the left side.
The picture you can see
on the right appears.
Normally, the range value test is carried out with a start value of 00.00 and a
final value of 99.99, with step lengths of 00.50 and refined step lengths of
00.10. In order to be able to alter these setup, this monitor page was inserted
before the actual test. Simply press the key Alter, and you will change over to
the corresponding entry field.
When all pre-settings are ready, please activate the key Start range value test.