User manual

User Manual Rayocomp PS 1000 Polar Page 2-4
When the Start key is pressed, the interferences can be seen on the right side,
and also the four polariser keys. The basic set up of the polariser is always
N = neutral, which means without polarisation.
1
In caption 1, the
current state of the
associated resonance is
displayed. In the
display mode, all
resonances are set to
n.t., which means not
tested. If a new
resonance is being
tested, the resonance
property is set to i.O.
at first, which means in
order = treatment
unnecessary.
Before beginning with the testing process, please consider, whether you are
testing yourself or a third party, i.e. a patient. In part 2 of the user manual, you
will find valuable information to assure exact measuring.
Now test with the sensor to find out, whether you achieve a rotation (left or
right motion) or a linear movement. A rotation means, that the field in the
organism linked to the interference is stable and therefore does not require
treatment. If, however, the achieved motion is linear, this patient suffers from
an energetic blockade. If it is irrelevant, whether the blockade is strong or
weak, you now press the button on the sensor in the direction of the spring
wire. The device will store a N / resonance. Then press the button of the sensor
to the right, and the next interference can be tested.
If you want to know exactly, which polarisation is most suitable for helping the
organism, or if you want to find out, whether the disturbance is strong or weak,
then press the button down after having tested a linear movement on N. Now
the polariser is switched over to polarisation +/-. If the sensor is now already
performing a rotation, the disturbance is not very strong. In this case, press the
button of the sensor to the right, and the next interference can be tested. If the
linear movement continues when set to +/- polarisation however, the
disturbance is stronger. Press the button down and test, whether the +
polarisation, which is now set, leads to a rotation means, that the + polarisation
is most suitable for harmonization. If still no rotation could be achieved, press
down the button of the sensor once more. Now you will see, that there is a
rotation on the – polarisation.