User's Manual

VerteX RTH Series H.8 and H.16 Series

 Open the system body and install a new disk (connect the data cable and the power cable).

 Connect power to the system and boot the system.

 Select {Menu} Æ {Setup} Æ {Storage} using the arrow keys and the Select button.

 A newly displayed disk will then be displayed as {New}.

 Select a newly installed disk using the arrow keys and the Select button and initialize the disk as a {Direct}

or a {Backup} disk. The following describes the method of setting a direct storage.

※Selecting {Direct-Init} or {Backup-Init} causes all data in the device to be erased. Therefore,

caution is required.

※While {Direct-Init} or {Backup-Init} is being set up, do not remove the device (may cause an

error when detecting the device).

※To use the external or portable storage device for system upgrade, set to {Backup-Init} in

the {New} item for {Main Setup} {Storage Device} {Local Storage Device Management}.

※When used in DVR equipment for the first time, a backup USB device will always be

detected in the {New} category. Therefore, a USB device in the {New} category must be set up

as {Backup-Init} prior to use for backup. A USB device that has gone through this procedure

will be detected in the {Backup} category when used again in the DVR equipment.

 {Direct} shows the status of the newly installed disk online.

C. Operation of the local storage device

 From the Manage Local Storage menu, select {Direct}, {Backup}, and {New} using the arrow keys.

 If there is a valid storage device in the corresponding tab, the desired storage device may be selected

using the arrow buttons.

 Select the storage using the Select button. Popup menus will then be displayed.

 Select menus using the arrow keys and the Select button.

D. Direct HDD Format

 Select the desired model in {Menu} Æ {Setup} Æ {Storage} and the window as shown below appears.

[Figure 5-40. Storage Offline]

 Select Offline and select the model as shown below..