Specifications

Page 2 of 4
5. Locate the tiny Molex connectors that connects your present battery pack/holder and the radio.
6. Carefully disconnect these connectors.
7. Remove the present battery pack/holder from the FT-817 battery compartment.
8. Take the One-Plug Power assembly and position it above the FT-817 battery compartment. The figure
below shows how the OPP+ is positioned once installed. Read Steps 9 & 10 before installing the
OPP+..
NOTICE: DO NOT use any conductive tool (e.g., screwdriver, knife, …) in the installation of your
OPP. DO NOT insert anything into the OPP+ power jack other than the proper size and type plug.
If you violate these instructions, you can damage the battery pack and the warranty will be void.
9. Carefully insert the OPP+ battery pack into the FT-817 battery compartment with the end of the battery
pack having the FAST Charge jack facing to your left. The battery pack slips under the right lip of the
battery compartment. Do not force.
10. Connect the tiny Molex connector from One-Plug Power to the connector from the radio. Position
these cables on the shelf under the left lip of the battery compartment as illustrated in the next
photograph..