Operating Manual

EVX-534 OpErating Manual
24
rEsEt
Press (or press and hold) the assigned
PF
key to reset
the RFC (Ready for Communication) condition.
call 1 to call 5
Press, (or press and hold), the assigned
PF
key to
send a pre-dened 2-tone Sequential Tone Group (on
an analog channel) or a pre-dened Digital Contact
List (on a digital channel).
codE up/doWn
Press, (or press and hold), the assigned
PF
key to
select a 2-Tone or 5-Tone encode code from the pre-
programmed encode list.
codE sEt
You can change the desired digit of the 5-Tone en-
code code using this function:

Press, (or press and hold), the assigned
PF
key.

Select the desired digit using the
[
A
]
/
[
B
]
keys,
then change the number using the
SIDE-1
/
SIDE-
2
buttons.

Press the
[
D
]
key to store the new setting. The
display indicates “- SET -” briey, then reverts to
the normal channel indication.
You may cancel the new setting by pressing
the
[
C
]
key. In this case, the display indicates
“- CANCEL -” briey.
spEEd dIal
Your Vertex Standard dealer may have pre-pro-
grammed Auto-Dial telephone number memories into
your radio.
To dial a number, press, (or press and hold), the as-
signed
PF
key, then press the
[
A
]
/
[
B
]
keys to select
the Auto-Dial memory number list provided by your
Vertex Standard dealer or Network Administrator,
then press the
PTT
switch. The DTMF tones sent dur-
ing the dialing sequence will be heard in the speaker.
call
Press, (or press and hold), the assigned
PF
key to
send a 2-tone or 5-tone sequential tone.
advancEd opEratIon
FCC ID: AXI11154620
IC: 10239A-11154620