User's Manual
EVX-5300/-5400 OpErating Manual
17
lonE workEr
Press (or press and hold) the assigned
PF
key to toggle the Lone Worker feature
“On” and “Off”.
The Lone Worker feature is designed to emit an alarm for 30 seconds when the
Lone Worker Timer (programmed by your Vertex Standard dealer) has expired. If
the user does not reset the timer by pressing the
PTT
switch, the radio switches to
the Emergency mode.
To revive the radio from the Emergency mode, just press (or press and hold) the
PF
key which is assigned the Emergency feature or turn off the radio.
group up/Down
(
This function is only available in the
EVX-5400
)
Press (or press and hold) the assigned
PF
key to select a different group of chan-
nels.
channEl up/Down
Press (or press and hold) the assigned
PF
key (generally the
[
]
/
[
]
key) to se-
lect a different channel within the current group.
spEED ch up/Down
(
This function is only available in the
EVX-5400
)
Press and hold the assigned
PF
key causes the radio to begin stepping (repeatedly)
upward or downward through the channels.
pri-1/pri-2
Press (or press and hold) the assigned
PF
key to recall the pre-programmed prior-
ity channel directly. This is pre-programmed by your Vertex Standard dealer.
pri-2 sEt
Press (or press and hold) the assigned
PF
key to toggle the current channel to the
priority channel 2 “enable” and “disable”.
pri-2 DisaBlE
Press (or press and hold) the assigned
PF
key to disable the priority channel 2 of
the group temporarily.
DirEct ch 1 to DirEct ch 4
Press (or press and hold) the assigned
PF
key to recall the pre-programmed chan-
nel directly. This is pre-programmed by your Vertex Standard dealer.
adVancEd opEratIon
FCC ID: AXI11144630
IC: 10239A-11144630
Vertex Standard LMR, Inc.