User's Manual

EVX-5300 OpErating Manual
12
advanced operatIon
dual watcH
The Dual Watch feature is similar to the SCAN feature, except that only two chan-
nels are monitored:
o
The current operating channel; and
o
The Priority-2 channel.
To activate Dual Watch:

Press (or press and hold) the assigned
PF
key.

The scanner will search the two channels; it will pause each time it nds a
channel on which someone is speaking.
To stop Dual Watch:

Press (or press and hold) the assigned
PF
key.

Operation will revert to the “Dual Watch Start” channel.
Fm-scan
(
Follow-me scan
)
The FM-Scan feature checks a User-assigned Priority Channel regularly as you
scan the other channels. Thus, if only Channels 1, 3, and 5 (of the 8 available
channels) are designated for “Scanning,” the user may nonetheless assign Channel
2 as the “User-assigned” Priority Channel via the FM-Scan.
To activate the FM-Scan, first select the channel you want to designate as the
“User-Assigned Priority Channel” and press (or press and hold) the assigned
PF
key. Then press (or press and hold) the Channel Up/Down key (generally the
[

]
/
[

]
key) to recall to the “Scanning Start” channel which has been programmed by
your dealer to activate the scanner. When the scanner stops on an “Active” chan-
nel, the User-assigned Priority Channel will automatically be checked every few
seconds; if activity is found on the User-assigned Priority Channel, the radio will
switch between it and the Dealer-Assigned Priority Channel, if any.
scan set
Press (or press and hold) the assigned
PF
key to add/delete the current channel to/
from your scanning list.
When you delete channel, the Transceiver Status Indicator (“
A
”, “
B
” or “
C
”) will
turn off, if the “SCAN CH” status is assigned to one of the Transceiver Status
Indicator. To restore a particular channel to your scanning list, press (or press and
hold) the assigned
PF
key again; the Transceiver Status Indicator will illuminates,
if the “SCAN CH” status is assigned to one of the Transceiver Status Indicator.
When the scanner is stopped, you may remove the channel from the scan list tem-
porarily by pressing (or press and holding) this key.