User's Manual

EVX-5300 OpErating Manual
11
prI-2 set
Press (or press and hold) the assigned
PF
key to toggle the current channel to the
priority channel 2 “enable” and “disable”.
prI-2 dIsaBle
Press (or press and hold) the assigned
PF
key to disable the priority channel 2 of
the group temporarily.
prI-2
Press (or press and hold) the assigned
PF
key to recall the pre-programmed PRI-2
(Priority-2) Channel directly. This is pre-programmed by your Vertex Standard
dealer.
dIrect cH 1 to dIrect cH 4
Press (or press and hold) the assigned
PF
key to recall the pre-programmed chan-
nel directly. This is pre-programmed by your Vertex Standard dealer.
scan
The Scanning feature is used to monitor multiple channels programmed into the
transceiver. While scanning, the transceiver will check each channel for the pres-
ence of a signal, and will stop on a channel if a signal is present.
EVX-5300
series
can scan both digital and analog frequency programmed channels simultaneously.
To activate scanning:

Press (or press and hold) the assigned
PF
key to activate scanning.

The scanner will search the channels of each channel, looking for active ones;
it will pause each time it nds a channel on which someone is speaking.

Press (or press and hold) the assigned
PF
key again to disable scanning. Op-
eration will revert to the programmed revert channel.
Note: Your Vertex Standard dealer may have programmed your radio to stay on
one of the following channels if you press the
PTT
switch during the scanning
pause:
o
“Scan Pause” channel (“Talk Back”)
o
“Last Busy” channel
o
“Priority-2” channel
o
“User Programmed” channel (“Select Channel”)
o
“Scan Start” channel
advanced operatIon