User's Manual

Hardware and Wiring Installation Guide 57
6.4 Installation Checklist
The table and inspection report in this section will be used to indicate the completed installation and test of
hardware and wiring. The installation codes will be as follows:
C = Cable checked I = Installed hardware
Make copies of the table and enter the numbers of the hardware as they are installed. Indicate a cable check
completion with a “C” and a hardware installation completion with an “I” in each numbered cell of the
table. The installer will be directed by the steps of the installation to make these entries as the checks and
installation are made.
Copies of the entries should be kept with other installation documentation.
Item Quantity Hardware
Installation
System
Installation
Installation Hardware
Sensor Cable
Collector Cable
UY connectors
UR connectors
Network Cable
Cable Labels
Cable ties
RJ 12
RJ 45 (for shielded cable use shielded RJ 45
connectors)
Versus Products
IR Sensors (VER-4422)
RF Sensors (VER-4450)
Supervised IR Sensor (VER-4442)
IR Serial Sensor (VER-4444)
Remote Stations (VER-4052)
Remote Stations (VER-4054)
Collectors (VER-2402)
Concentrator (VER-2015)
Locator Badges (VER-1700)
Personnel Badges (VER-1780)
Asset Tags IR/RF Anti-Tamper (VER-1830A)
Asset Tags IR/RF (VER-1830B)
Digital I/O Board (VER-3010)
External Relay Board (VER-3015)
Software Licenses
Software Backups
Installation Checklist page 1 of 2