User's Manual

Versus Technology, Inc.
Hardware and Wiring Installation Guide 39
4.10.3 Proper Mounting of the Versus Remote Station
This small, wireless, radio frequency (RF) device can be mounted on or in a wall
or some other non-metal surface. When the button is pressed, a signal is sent to
the system, notifying it to activate a customizable preprogrammed response. The
button lights up when it is pressed, giving a visual cue that the signal has been
sent.
The remote station is designed around a single gang face plate, device box and a
back mounting plate. The face plate is attached to the device box by two security
screws. This device can be mounted in or on the wall or other surface.
To install on a wall or other non-metal surface, verify the correct orientation required and then
mount the back mounting plate to the desired wall or other surface. Attach the device box to the
back mounting plate. Install the battery and tighten with the provided Velcro straps until the
battery is secure. Attach the face plate to the device box with the security screws. To test the
remote station, verify that the button lights up when the button is pushed.
To install in a wall, verify the correct orientation required. The wall should have a plastic gang
box installed. Install the battery and tighten with the provided Velcro straps, until the battery is
secure. Attach the face plate to the plastic gang box in the wall with the appropriate length screws.
To test the remote station, verify that the button lights up when the button is pushed.