User's Manual

Versus Technology, Inc.

38 Versus Information System

1. Thoroughly clean the mounting surface with an alcohol swab

of a 50/50 or 50/70

isopropyl alcohol/water solution,

removing all dirt and grime. Failure to complete this step

will cause the adhesion to fail.

Wipe the surface dry with a lint-free cloth or napkin. Be

sure that no fibers are left behind on the surface.

3. Peel off one liner side of the adhesive tape. Be sure to use the

pull tabs and tape liners to prevent contaminating the

adhesive tape with skin residues.

4. Position the tape over the asset tag base, making sure the anti-

tamper button fits through the provided hole. Using your

thumb, apply pressure over the entire base to seal the tape.

5. When ready to mount the tag to the asset, remove the second

liner using the pull tab. Do not touch the adhesive surface or

you will compromise the adhesive ability of the tape.

6. Apply the tag base firmly to the cleaned area of the asset to

allow the adhesive tape to bond with the surface. A silicone hand exercise ball can distribute pressure

evenly. Once applied, remove the tag’s cover and leave the tag undisturbed for as long as possible

(preferably at least eight hours) to allow the adhesive to cure. Some surfaces may require a 72 hour cure

period to achieve satisfactory adhesion.

7. After the cure time has expired, install the battery and case cover. The battery and cover should be

installed only after the base is affixed to the mounting surface and the cure time has expired. Failure

to follow this procedure may result in the tag lifting and decreased battery life.

3M does not warrant that VHB will adhere to all materials and surfaces but rather specifies that

you must test the surface that you intend to attach the tag. If the above instructions are followed

and the VHB will not remain adhered to the asset over time, the tag must be attached using

conventional fasteners.

Step