User's Manual

Versus Technology, Inc.
Hardware and Wiring Installation Guide 19
Punch-down Block Wire Organization List
Collector #: 3265458142
Collector alias: C1
A copy of this chart is located in Section 6.5 and can be printed for your use. Use one chart for
each collector on the system. Each successive chart should have room/receiver numbers starting
with the next incremental number from where the previous chart left off. Using this chart will
assist you with labeling cable wires appropriately.
3.3.5 Mapping the Relay Device Locations
If the system includes relay-controlled devices, such as corridor lights or door locks, they should
be mapped out on the floor plan of the facility. We suggest a numbering scheme such as R1-1, R1-
2, R1-3, etc. Label each end of the wires to the relay-controlled devices with the same numbers. In
addition, you will need to document the relay numbers and relay cable IDs on the Punch-down
Block Organization List located in Section 6.5. For each room on the list that will have a corridor
light installed, enter its numerical position on the relay board, starting at 0. In addition, there is a
Relay Board Organization List in Section 6.8 for mapping the relay board with the appropriate
room names and light colors. When you connect the relay wires to the relay board, you will need
to refer to the list and connect them accordingly. The two-page form has numbers 0-47 on the first
page and 48-95 on the second representing two relay boards with 48 relays each. Use one two-
page form for each relay controller board.
Punch-
down
block
pair Cable ID
Wire
Color
Zone description
(room name)
Receiver/
Room # Relay # Verified
1
C1-1 John’s Office 1
2
C1-2 Bob’s Office 2
3
C1-3 Patient Room 120 3 0,1,2,3
4
C1-4 Patient Room 122 4 4,5,6,7
5
C1-5 Patient Room 124 5 8,9,10,11
6
C1-6 Patient Room 125 6 12,13,14,15
7
C1-7 Hallway
7
8
C1-8 Hallway
7
9
C1-9 Nurse’s Station
8
10
C1-10 Nurse’s Station
8
11
C1-11 RF Nurse Station 9
12
C1-12
13
C1-13
14
C1-14
15
C1-15
16
C1-16
17
C1-17
18
C1-18
19
C1-19
20
C1-20
21
C1-21
22
C1-22
23
C1-23
24
C1-24
Building: Main Facility
Floor: 1st
Room #: Comm. Room 1
If there is more
than 1 IR sensor
in a room or area,
you can give them
the same receiver
number, but
unless you are
using the PAS
system, do not
assign an RF and
IR sensor the
same receiver
number.