User's Manual

Versus Technology, Inc.
12 Versus Information System
5. Connect the Concentrators to the Network Badge Server and Data Server
Configuration Manual, Section 3.4
6. Add the Concentrator Numbers to the Badge Server Badge Server and Data Server
Configuration Manual, Section 3.5.1
7. Install the Data Server Badge Server and Data Server
Configuration Manual, Section 4.1
8. Start the Data Server Badge Server and Data Server
Configuration Manual, Section 4.2.1
9. Configure the Data Server Badge Server and Data Server
Configuration Manual, Section 4.2
10. Install Configuration Utilities on Server for database
configuration
Configuration Utilities Manual, Section 2
11. Configure sensors and collectors in the Sensors and
Receivers Utility
a. Add room names
b. Add Collectors
c. Map Rooms to Collectors and Sensors,
making sure to note RF sensors in the Type
column
Configuration Utilities Manual, Section 3
12. Add badge types in the Badge Type Utility
• Add patient, caregivers, wall badges, and
any other badge types needed
Configuration Utilities Manual,
Section 4
13. Test locations using Walking Setup
Configuration Utilities Manual,
Section 3.7
14. Set up other Configuration Utilities as needed Configuration Utilities Manual
15. Install client software on workstations Individual client manuals
16. If the system includes RF sensors, test them using
the Frequencer (TCP/IP)
Hardware and Wiring Installation Guide
Section 4.7 and Badge Server and Data
Server Configuration Manual, Section
5.1
17. Create Backup
• Most important file to back up is the
pdcs.mdb file
Configuration Utilities Manual, Section
13.4
18. Verify system by checking off Punch-down Block
Organization List, Relay Light List, and
Communication Room checklist
Hardware and Wiring Installation Guide
Section 6
19. Final install checklist including training information Hardware and Wiring Installation Guide,
Section 6