User's Manual

28 Versus Technology, Inc.
5.1 Badge Battery Replacement
Warning! A low battery may affect system performance. Change low batteries at first indication.
Note: Static electricity can damage batteries. When changing badge batteries, it is critical to be
grounded, such as by using a static strap and an Electro-Static Device mat to protect from any
shock that would damage the battery or the badge.
The table below provides instructions on how to replace badge batteries. Remember to use an anti-static
strap and an Electro-Static tabletop mat when changing badge batteries.
Badge Battery Type Replacement Instructions
Locator Badge
VER-1700
Lithium, 3.5V
750 mAH
1. Place the Locator badge face down on an Electro-Static mat.
2. Locate the screw on the back of the badge. Using a small Phillips
head screwdriver (or security screw driver), remove the screw and
the back cover of the badge and flip it over to expose the battery.
3. Gently lift the battery from the board using your thumb and finger.
4. Insert the new battery into the lead holes. Replace the top cover and
gently tighten the badge screw.
Personnel
Badge
VER-1780
3V Lithium
CR2477
950 mAH
1. Locate the screw on the back of the badge. Using a small Phillips
head screwdriver (or security screwdriver), remove the screw and
battery cover.
2. Using a jumper wire, touch the ends of the
jumper wire to the contacts inside the
battery compartment to remove any
residual charge in the badge.
3. Place the battery in the battery compartment with the + facing up.
4. Replace the battery cover, making sure to insert the tabs first.
5. Replace the screw.
Tabs on battery
cover.