User's Manual

14 Versus Technology, Inc.
3.4 Use of Unauthorized Components
The VIS system integrates hardware and software to create a safe, reliable and efficient system. Use of
components or connection to equipment not approved by the manufacturer is NOT recommended and
will invalidate any and all warranties.
Approved third-party components include wire and connectors, terminal blocks, and other
interconnection means only. Questions regarding the use of third-party equipment or components
should be directed to your dealer for clarification before being connected to your system.
3.5 List of Materials
Installation activities require a minimum amount of materials, some of which may be purchased by the
installer independent of Versus. For materials supplied by Versus, refer to the packing list and confirm
that all listed hardware and wire can be identified. For installer-purchased material, insure that the
remaining materials are available for the installation shown by the floor plan schematic diagram.
3.6 List of Tools
Some installation activities require special tools. Following is a list of recommended tools.
Cable stripper
Cordless Drill
Diagonal Clippers
Digital Multi-Meter
Electric Screw Driver
Ethernet Supplies
Fishtape
Hole Saw 2 3/8” Drill Attachment
Level
Mounting Screws
Nut Drivers
Paper/Pens
Punch
-
down Block Tool
-
Type 66 or
Bix,
whichever is appropriate
RJ-45 Testers
RJ Connector Terminator Tool Kit
Scissors
Screwdriver Assortment
Splice Crimp Tool
Small Hammer
Electrical Tape
Tape Measure
Twist Ties
Utility Knife
UY Connectors
Vise grip Pliers
Walkie Talkies (helpful for testing sensors)
Weidmeuller Patch Check Plus
Wire Strippers