User's Manual

Hardware and Wiring Installation Guide 13
the number and the room name. You can also add the receiver numbers, which will be used for
configuring the software. Number the receivers with incrementing numbers (1, 2, 3…). If there is more
than one sensor in a particular area, they will have the same receiver number. See the following
example chart.
Punch-down Block Wire Organization List
Collector #: 3265458142
Collector alias __C1_________
There is a copy of this chart in section 6 that can be printed out for use. There will be one chart for
each collector on the system. The chart for the next collector would have receiver numbers starting
with the next incremental number from where this one left off. This chart will assist you with labeling
the cable wires appropriately.
Punch
-
down
block
pair
Cable ID
Wire
Color
Zone description (room
name) Receiver # Relay # Verified
1 C1-1 John’s Office 1
2 C1-2 Bob’s Office 2
3 C1-3 Patient Room 120 3 0,1,2,3
4 C1-4 Patient Room 122 4 4,5,6,7
5 C1-5 Conference Room 5
6 C1-6 Conference Room 5
7 C1-7 Patient Room 121 6 8,9,10,11
8 C1-8 Patient Room 123 7 12,13,14,15
9 C1-9
10 C1-10
11 C1-11
12 C1-12
13 C1-13
14 C1-14
15 C1-15
16 C1-16
17 C1-17
18 C1-18
19 C1-19
20 C1-20
21 C1-21
22 C1-22
23 C1-23
24 C1-24
Building: ___
Main Facility
_______
Floor: __1st______________
Room #: ___Comm. Room 1_____
If there is
more than 1
sensor in a
room or area,
you can give
them the
same receiver
number.