Installation Manual

Versus Technology, Inc.
DT10000-A0001 21 Revision 8 December 1998
Figure 7-1. Punch-down Block Diagram
Sensor No. 1 pin-pair, 2 rows
Sensor No. 2 pin-pair, 2 rows
25
t
h
double row of pins is
not used.
Sensor Wire
Side
Sensor connections continue
through 24 maximum.
Sensor wiring should be tested at these
pins before bridge clips are installed.
Check for isolation at this point.
Collector side
After sensor wiring has been verified, bridge
clips are installed across these pins for each
active pin-pair.
Collector Connection