Installation guide

www.versitron.com

Port Setup

This page is used to set the port configuration for each port. As auto-negotiation function is

enabled, speed and duplex settings specify the highest port ability for negotiation process

between the switch and the auto-negotiation capable link partner. When auto-negotiation

function is disabled, speed and duplex settings specify the forced port configuration for the

connection. Setup options are:

Auto-negotiation Enabled, disabled

Speed 100M = 100Mbps, 10M = 10Mbps

Duplex Full = full duplex, Half = half-duplex

It is recommended to set auto-negotiation enabled in most cases and set it disabled when

connecting to an auto-negotiation incapable full duplex device.

[Apply] Click to make the setup effective immediately.

3.3 IP Setup

This page includes the following functions:

IP Status Display information of current IP used.

If the current IP address is labeled (DHCP), it means the IP is assigned by

DHCP server.

IP Setup Set static IP address to be used when DHCP is disabled or when no DHCP

server is available.

DHCP Setup Enable to get and use dynamic IP address assigned by DHCP server. Disable

to use Static IP setting.

Any change or click [Apply] will not take effect until after next bootup.