Installation guide

When connecting to a 100BASE-FX device using fiber cable,
make
sure the TX connector of the adapter is connected to the RX con-
nector of the device and RX connector is connected to the T
X
connector of the device.
Connecting
100BASE
-
FX
Fiber
Cable
In order to have a reliable communication between two ends,
the
speed and duplex configuration of the adapter's FX port and
the
device at the remote end must be same. Configure the driver of
the
adapter
as
follows:
Link/Speed
Setu
p
100BASE
-
FX
Connection
Auto Mode 100Mbps, Full duplex
100M_Hal
f
100Mbps,
Half
duplex
Other
settings
are
not
suggested.
14