Installation guide

2.
Installing
the
Adapter
This chapter describes how to install the Fast Ethernet PCI
adapter
in a PCI computer and how to connect the adapter to the
network.
Before installing the adapter, you need the following:
- A computer system that is compliant with the PCI specifica-
tions version 2.1 or later.
- An available PCI bus master slot in the computer
- A Wake on LAN cable (supplied with the adapter)
- The adapter driver diskettes (or CD supplied with the adapter)
- Fiber cables
2.1
Installing
the
Adapter
To install the adapter in your computer, follow these steps:
1. Turn off the power to the computer and disconnect all cables
connected to the computer.
2. Remove the computer's cover.
3. Unscrew and remove the slot cover from the PCI bus slot that
you plan to use.
4. Install optional Boot ROM, if you want to use the remote boot
ROM function. Refer to Appendix for more information.
5. Insert the adapter into the slot and secure the screw.
6. Configure WOL, if required. Refer to 2.2 for the details.
7. Replace the computer cover and reconnect all previously
connected cables.
11