Manualshelf

Assembly Instructions

ManualsBrandsVersatube Building Systems ManualsCarportsClassic 20 Ft. x 20 Ft. Canopy
10111213141516171819
INSTALLING VINYL EDGE TRIM:
Install vinyl edge trim on front, back and side edges of sheet metal panels. Start at one corner and push the trim securely
over the sheet metal edge. Install the trim on the gable ends first starting at one corner, up along the gable and down to
the other corner. Install vinyl edge trim on both side edges of the carport. Clip the trim flush with the edge of the trim on
the gable ends. It may help to use a small hammer to fit trim over major ribs. Use your tin snips to cut the trim.
VINYL TRIM, GABLE END
VINYL TRIM, GABLE END
VINYL TRIM, SIDE EDGE
BUTT SIDE EDGE TRIM UP TO GABLE END TRIM
PAGE 19
IMPORTANT:
All of the metal shavings created by the installation of self-drilling screws must be washed or swept off of
the carport roof. These raw metal shavings will rust and stain the roof panels.