SDS

ManualsBrandsVersatrim ManualsFlooring & RugsMarmoleum 94" Donkey Island T-Molding

Material Safety Data Sheet

Occupation Safety and Health Standard

29CFR1910.1200

Section 1 Chemical Product and Company Information

Product Name: Versatrim (Manufactured molding for wall and floor application)

Manufacturer: Versatrim Inc. / Profilform US, Inc.

860 Commerce Dr.

Henderson, NC 27537

Material Uses: Decretive and molding for residential and commercial uses

Transition molding for floor and carpet uses.

Section 2 Composition and Ingredients

Component % by weight CAS # Hazardous Ingredients

1. Medium Density Fiber Board

2. Micro Resin Laminate

3. Adhesive

4. High Impact Polystyrene

None

9003-55-8

A. Wood Dust

B. Melamine Urea Formaldehyde Resin (less

than 1% free formaldehyde (CAS # 50-00-0)

gas

C. Paraffin Wax Emulsion (CAS # 8002-74-2)

None Known

Styrene-Butadiene Ploymer

Section 3 Hazards Identification

1. Quarter Round /Wall Base /Landing Stair Nose

Moldings

2. End Cap / Transition/Reducer Moldings

None Known as product is sold

A. Minor wood dust is produced when sawing or

sanding

See Section 8 for protection

B. Minor Formaldehyde is produced when not stored

according to recommendation.

See Section 7. For recommendations

None know as products are sold

A. Minor dust and chips are produced when sawing or

sanding these products

See section 8 for personal protection

B. High concentration of dust or chips may produce a

minor fire hazard

See section 6 for proper clean-up and disposal of

chips and dust.

Summary of content (3 pages)

PAGE 1
Material Safety Data Sheet Occupation Safety and Health Standard 29CFR1910.1200 Section 1 Chemical Product and Company Information Product Name: Versatrim (Manufactured molding for wall and floor application) Manufacturer: Versatrim Inc. / Profilform US, Inc. 860 Commerce Dr. Henderson, NC 27537 Material Uses: Decretive and molding for residential and commercial uses Transition molding for floor and carpet uses. Section 2 Composition and Ingredients Component % by weight CAS # Hazardous Ingredients A.
PAGE 2
Section 4. First Aid Procedures There are no First Aid requirements for these products as sold. When sawing or sanding minor chips and dust will be produced. See Section 8. For Personal Protection Section 5 Fire Fighting Information This material is not flammable according to OSHA classification. It will burn at a nominal ignition point of 475 degrees F. Section 6 Accidental Release Measures Very small amounts of wood dust may be released during sawing and sanding of this product.
PAGE 3
TSCA: As sold these materials comply with TSCA inventory requirements OSHA: These products as sold are not classified as Hazardous under the OSHA Hazards Communications standard (29CFR1910.1200) Under normal storing and stocking condition there would not be sufficient formaldehyde release to provide harmful concentrations. Wood dust from sawing and sanding may be irritating. CERCLA: Section 16: Other Information The data in this document is based on information available at the time of publication.