Specifications

VW-DP Motion Detector Quick User Overview
On power up:
Flash LED
Send RF power up message
While tamper switch open and for 5 minutes after tamper switch closed:
PIR is in “Walk Test Mode”
If PIR triggers: flash alarm LED on for 2 seconds, send reed switch / loop alarm message
After PIR alarm clears, send reed switch / loop alarm clear message
Approximately 12 second hold-o between subsequent reed switch / loop alarm message transmissions and LED flash. This hold-o is partially
determined by the A&R PIR module ALARM signal operation.
From 5 minutes after tamper switch closed:
PIR is in “Normal Operation Mode”
LED alarm indicator disabled
If PIR trigger: send reed switch / loop alarm message
After PIR alarm clears, send reed switch / loop alarm clear message
180 second (3 minute) hold-o between subsequent reed switch / loop alarm message transmissions.
Protocol Selection with Switch:
When the Switch is ON -> transmits using QOLSYS, INTERLOGIX (319.5 Mhz).
When the Switch is OFF -> transmits using Honeywell 5800, 2GIG (345MHz).
Quick
Start Guide