Product Card
Table Of Contents
- Cloud Services Gateway 300 Series
- At a Glance
- CSG300 Appliance Models
- Chassis Views
- CSG300 Series Appliance Specifications
- Chassis Specifications
- CSG300 Series Appliance SKUs
- Regulatory Compliance
- Certifications
- Export Control Information
- Front and Rear Panel Components
- Front Panel
- Rear Panel
- Additional Information
- Network Interface Card Modules
- LTE Modem Module
- Embedded WiFi Module
- Interface Numbering
- Power Supply and Airflow
- AC Power Supply
- Airflow Requirements
- Installation Guidelines
- General Safety Guidelines
- Federal Communication Commission Interference Statement
- Prepare the Site for Installation
- Site Preparation Guidelines
- Environmental Requirements
- Rack Requirements
- Airflow Requirements
- Install a CSG300 Series Appliance
- Unpack a CSG300 Series Appliance
- Packing List for a CSG300 Series Appliance
- Mount a CSG355 or CSG365 Appliance in a Rack
- Connect a CSG300 Series Appliance
- Step 1: Connect Earth Ground to a CSG300 Series Appliance
- Step 2: Connect AC Power to a CSG300 Series Appliance
- Step 3: Configure a Management Console to Connect to a CSG300 Series Appliance
- Step 4: Connect a CSG300 Series Appliance to a Management Console
To mount the appliance, ensure that you have the following tools:
• Number 2 Phillips (+) screwdriver
• Tape measure
To mount a CSG355 or CSG365 appliance in a four-post 19-inch rack:
1. Place the appliance chassis on a flat, stable surface.
2. Check the internal dimensions of the rack with a tape measure. The appliance is 22 cm wide (about 8.6 inches)
and must fit within the mounting posts.
3. Allow a minimum of 0.5 RU space above the appliance for airflow, to allow hot air to flow out. However, it is
recommended that you allow 1 RU space above the appliance.
Figure 2: Space a CSG300 Series Appliance when Rack Mounting
4. Attach the two mounting ears to each side of the appliance chassis using the eight mounting ear screws that are
shipped with the appliance. Use four screws to attach each mounting ear.
Figure 3: Attach the Mounting Ears to a CSG300 Series Appliance
https://docs.versa-networks.com/Versa_Internal/WIP/Antony/Cloud_Services_Gateway_300_Series
Updated: Tue, 01 Dec 2020 03:50:36 GMT
Copyright © 2020, Versa Networks, Inc.
27