Product Card
Table Of Contents
- Cloud Services Gateway 300 Series
- At a Glance
- CSG300 Appliance Models
- Chassis Views
- CSG300 Series Appliance Specifications
- Chassis Specifications
- CSG300 Series Appliance SKUs
- Regulatory Compliance
- Certifications
- Export Control Information
- Front and Rear Panel Components
- Front Panel
- Rear Panel
- Additional Information
- Network Interface Card Modules
- LTE Modem Module
- Embedded WiFi Module
- Interface Numbering
- Power Supply and Airflow
- AC Power Supply
- Airflow Requirements
- Installation Guidelines
- General Safety Guidelines
- Federal Communication Commission Interference Statement
- Prepare the Site for Installation
- Site Preparation Guidelines
- Environmental Requirements
- Rack Requirements
- Airflow Requirements
- Install a CSG300 Series Appliance
- Unpack a CSG300 Series Appliance
- Packing List for a CSG300 Series Appliance
- Mount a CSG355 or CSG365 Appliance in a Rack
- Connect a CSG300 Series Appliance
- Step 1: Connect Earth Ground to a CSG300 Series Appliance
- Step 2: Connect AC Power to a CSG300 Series Appliance
- Step 3: Configure a Management Console to Connect to a CSG300 Series Appliance
- Step 4: Connect a CSG300 Series Appliance to a Management Console
Environmental Requirements
• Ensure that the area in which you operate the appliance has adequate air circulation so that the cooling system
functions normally. Ambient air temperature may not be sufficient to cool the chassis to acceptable operating
temperatures without adequate circulation.
• Avoid temperature extremes.
• High humidity conditions can cause moisture to penetrate into the chassis. The appliance can operate in relative
humidity of 10% to 85%, non-condensing.
Rack Requirements
You can mount a CSG355 or CSG365 appliance in a 19-inch four-post rack using slide rails. Table 1 lists the rack
requirements.
Table 1: Rack Requirements for a CSG300 Series Appliance
Requirement Guidelines
Rack type
Use a 19-inch four-post rack that has bracket holes spaced at 1 U (1.75 in. or 4.45 cm) increments,
and that has panels strong enough to support the weight of the appliance.
Rack size
Comply with the size and strength standards of a 19-inch rack. Ensure that the rack rails are spaced
wide enough to accommodate the external dimensions of the appliance chassis. Ensure that the
spacing of rails and the adjacent racks allows for proper clearance around the appliance and the
rack.
Rack firmly
secured to
building
structure
Secure the rack to floor brackets and to ceiling brackets to ensure maximum stability.
Airflow Requirements
A CSG300 series appliance uses fan-based cooling. Passive cooling occurs by airflow through the vents on the side of
the appliance.
When planning your site for installing a CSG300 series appliance, ensure that the vents on the side of the unit are never
blocked. Covering the vents prevents heat from dissipating out of the appliance, which can cause the chassis to
overheat and then shut down.
Install a CSG300 Series Appliance
This article provides instructions about how to unpack a CSG300 series appliance and how to mount a CSG355 or
CSG365 appliance in a 19-inch rack.
https://docs.versa-networks.com/Versa_Internal/WIP/Antony/Cloud_Services_Gateway_300_Series
Updated: Tue, 01 Dec 2020 03:50:36 GMT
Copyright © 2020, Versa Networks, Inc.
23