Quick Start Guide

– 1 –
Rackmount the Device
1. A
ttach each of the rear-post brackets to the switch using six of
the included bracket screws.
2. Use the rack screws to secure the switch in the rack.
Adjust Rear-Post Bracket Ears
1. Lock the position of the rear-post bracket ears using the included
position-locking screws.
You can adjust the rear-post bracket ears to fit different rack
depths from 56 cm to 75 cm.
Ground the Device
1. Ens
ure the rack is properly grounded and in compliance with
ETSI ETS 300 253. Verify that there is a good electrical
connection to the grounding point on the rack (no paint or
isolating surface treatment).
2. Attach the grounding wire (#18 AWG) to the grounding point
on the device rear panel. Then connect the other end of the wire
to rack ground.
Connect Power
1. Ins
tall two AC PSUs in the device.
2. Connect an external AC power source to each PSU.
3. Push the power button to power on the device.
Wa
rning: This equipment is not suitable for use in
locations where children are likely to be present.
A
vertissement:
Cet
équipement ne peut pas être utilisé
dans des endroits où des enfants sont susceptibles d’être
présents.
1
1
2
2
1
Ca
ution:
Th
e earth connection must not be removed unless
all supply connections have been disconnected.
Att
ention:
L
e raccordement à la terre ne doit pas être retiré
sauf si toutes les connexions d’alimentation ont été
débranchées.
3
2
1
4
2
1
E082
020-CS-R01
15020000xxxxA
Q u i c k S t a r t G u i d e
Cloud Services Gateway
CSG1300 | CSG1500|CSG3300|CSG3500
1. Clo
ud Services Gateway CSG1300 or CSG1500
2. Rack mounting kit—4 rack screws, 2 rear-post brackets, 2
rear-post bracket ears, 20 screws, and 2 ear-locking screws
3. 2 LTE antennas
4. 2 Wi-Fi antennas
5. Power Cord
6. Console Cable—USB to RJ-45
Package Contents
2
5
6
1
3
4