User/Service Guide

14
OVEN FITTING OUT
• Assemblethewirerackstotheovenwallsusingthe
2screws(Fig.3.1).
• Telescoping sliding shelf support (g. 3.2): The
telescopicslidingshelfsupportmakesitsaferand
easiertoinsertandremovetheovenshelf.Itstops
whenitispulledouttothemaximumposition.
 Important! When installing the sliding shelf
support,makesurethat:
- YouttheRHandLHslidingguidesonthewire
support(g.3.2).
- YoupresstheRHandLHslidingguidesagainst
thexingwires(gs.3.2a,3.2b).Youwillheara
clickasthesafetylocksclipoverthewire.
- You t the oven shelf above the sliding shelf
support(gs.3.2c,3.2d).
- You slide,on theguidesinside theoven cavity,
theslidingshelfsupportwiththeovenshelftted
above:
a. theovenshelfshallrunouttowardstheoven
door;
b. theshortbendonthewiresupportshallface
theinsideoftheoven;
c. theovenshelfmustbettedsothattheguard
railfacestheinsideoftheoven.
• Positionthebroilingpan
above the oven shelf
(seepage12).
• Todismantle,operatein
reverseorder.
To remove the RH and
LH sliding guides from
thewiresupport:
- Find the safety locks.
These are the tabs
thatclipoverthexing
wire (arrow 1 in g.
3.2e).
- Pull the safety locks
away from the xing
wire to release the
slidingguide (arrow 2
ing.3.2e).
3
Fig. 3.1
LH
sliding
guide
RH
sliding
guide
Fixingwires
Guardrail
Longbend
Shortbend
Wiresupport
1
2
2
1
3 2
4 5
Fig. 3.2 Fig. 3.2a
Fig. 3.2c Fig. 3.2b
Fig. 3.2d Fig. 3.2e
IMPORTANT: The
oven shelf must
beusedonlywith
telescopic sliding
shelf support
correctly in place.
IT IS NOT
POSSIBLE to t
the oven shelf
directly on the
guides inside the
oven cavity.