Operating instructions

Instal. GAL
A
®
37 / 40
VERO DESIGN NV © all rights reserved [phone]
Installation instructions Operating instructions
G
A
L
A
Maintenance
Open the fireplace when it’s cold :
Combustion area :
Only dust with a duster. Do not use a moist or wet cloth, this may cause corrosion!
If necessary, you can clean the back of the fireplace with a steel brush, dust it and repaint the
back with special VERO DESIGN paint.
Ignition pin :
Gently and very carefully you must clean the ignition pin with the finest
sandpaper once a year. All the dust and corrosion will be removed.
Make sure that the ignition pin never bends or moves!
Decoration material :
Remove the stones from the fireplace and put them in water with detergent. Clean them and
rinse them with cold water. Put the stones back on the fireplace after they are dry (at least 24h).
Make sure that the ignition pin never bends or moves!
Ceramic glass :
You can clean the glass as much as you want with a detergent. Make sure that the glass is
dry before you put the frame back in the fireplace. Never let the glass dry when the frame
is reinstalled (may cause corrosion).
Fresh air supply, flue :
Make sure that the fresh air supply is not covered . Check the flue and have
it swept according to local regulations, once a year by a professional chimney-sweeper.