Operating instructions

Instal. GAL
A
®
33 / 40
VERO DESIGN NV © all rights reserved [phone]
Installation instructions Operating instructions
G
A
L
A
Problems and solutions
Flames
B - 6
B - 5
B - 4
LED 1
B - 1
B - 2
B
-
3
The first person to contact is your professional dealer.
LED-indication on the remote control does not light up when lighting
Replace batteries ( 2 x 1.5V, AAA, LR03)
The remote control does not respond
Replace batteries ( 2 x 1.5V, AAA, LR03).
The receiver does not registrate the signal : move closer to the appliance and
point at the opening in the middle of the lower frame.
Make sure that the infra-red eye is not covered.
The fireplace does not light
Put the plug in the socket.
Press buttons 3 and 4 at the same time for about 15 sec., the LED-indication lights
5 times.
After the pilot flame has extinguished, you must wait at least 5 minutes before you can
restart.
Do not manipulate the ingnition pin of the pilot flame !
The fireplace ignites but there are no flames
Open the gasline.
After a period that the fireplace has not burnt, the gasline is empty. By restarting the
fireplace, the gasline is purged and removes the air in the gasline. This can take a while,
depending on the lenght of the gasline.
Remove the stones on or against the pilot flame.
The fireplace ignites, pilot flame burns but extinguishes immediately
Remove the stones on or against the pilot flame.
Insulation that is put around the pilot flame has to be checked and put back in its place,
if necessary it has to be replaced.
Mechanism of the pilot flame needs to be replaced (by fitter).