Operating instructions

[3.2] Filling the water bottle

• Open the screw top of the water bottle.

• Fill with distilled water up to the maximum mark.

• Close the screw top rmly again.

CAUTION: Only distilled water without additives may be used as cleaning liquid

[3.3] Bleeding the pump

CAUTION: Must be carried out each time the bottle has been lled!

• Release the copper coupling on the yellow hose between the pump and the pole.

• Switch on the pump by pressing the button on the handle of the pole (arrow).

• When water sprays from the open coupling piece, the ends of the hoses can be reattached and the

appliance is ready for use.

[3.4] Charging the battery pack

• Insert the charger into a mains socket (100 to 240V, 50 / 60 Hz).

• The green “POWER” lamp on the charger lights up and the yellow lamp lights up briey.

• Attach the battery pack to the charger via the grey plug connection. As a sign that it is charging,

the yellow “CHARGE” LED will light up. If the battery pack is still charged, the yellow LED will not

light up!

• When the battery is depleted the charging time is three hours.

• When charging is completed, the yellow “CHARGE” LED will turn o.

CAUTION: The battery pack may only be charged using the charger supplied along with it!

The charger may only be used for charging the battery pack used in the TopLock

Indoor Aquasoft system!

3.5 Attaching the pads

Press the pad to suit the job as straight as possible onto the pad holder. As soon as it has become

soiled, remove the pad and wash it in accordance with the care label. (Detailed washing instructions

are available from VERMOP).

3.6 Changing the Velcro strips on the pad holder

If necessary, the Velcro strips on the pad holder and the pad holder narrow can be removed and

replaced by new strips. To do so, pull o the cap on the narrow end of the holder, pull o the Velcro

strips and replace with new Velcro strips. Then replace the cap and attach rmly. Suitable Velcro

strips are available from VERMOP.