Operating instructions

28 20300293
Resolution Direct Vent Gas Fireplace


1. Place rock wool on the front burner to provide glowing
embers. For best results, pull the rock wool apart into
dime size pieces and place on top of burner. Also place
the same size ember over the carry over parts on the
rear burner. 

2. Distribute one layer of rock wool to cover the burner.
Figures 34 & 35
3. Place the logs on the burner. Refer to Log Placement.
Light unit and after 15 minutes, check burner ame and
glow. Refer to Burner Flame, Page 44.
FP2155
ember placement
FP2155
Figure 34 -
Rockwool placement






1. Remove the trapezoidal light shroud located at the back
of the rebox by unfastening the three screws.
2. Disassemble the trapezoidal light shroud by unfastening
the four screws which secure the front to the back. Set
lens with the orange painted surface toward the bottom.
Center the lens right to left. Reassemble the front to the
back and set the side.
3. Place the right side panel by sliding it at an angle to clear
the grate. Set the panel straight up and bring forward
until it comes in contact with the reverse bend located
at the front of the rebox. Use one of the brackets and
screws provided to secure the panel in place.
4. Place the rear lower panel by setting it over the channel
behind the light socket. Make sure the grout line lines
up with the one on the side.
5. 
Place
the rear upper panel in place by resting it over the rear
lower panel and sliding it behind the right side panel.
While holding the rear upper panel in place, slide the
left panel at an angle to clear the grate. Set the left side
panel straight up and release the rear upper panel.
Secure the left side panel in place using the second
bracket and screw provided in the kit.
6. Loosen the four (4) screws securing the grate to burner
and place the front hearth brick simultaneously and pull
toward the front away from the burner. This is critical
for balancing air ow around the front burner. Retighten
the grate screws.
7. Install the halogen light bulb provided with the unit
(inside the log set). Do not touch light bulb directly with
ngers.
8. Replace the trapezoidal light shroud removed in step
#1 by sliding it over the light bulb and sockets. Be care-
ful not to damage the light bulb. Align the holes on the
deector with the hole on the rear channel and secure
in place.