User`s manual

30005801
9
Safety

Never use Natural Gas in a Grill that
has been congured to burn Propane
Gas, (and never use Propane Gas in
a Grill that has been congured to use
Natural Gas) to avoid possible bodily
injury. Always consult the Rating Label
on the back of the Grill to conrm that
it has been congured to burn Propane
Gas.
Always install the pressure regulator
and Type 1 propane gas supply cou-
pling and hose that has been provided
with your Propane Grill, as pictured in Figure .
• Always install a standard 0 lb. propane cyl-
inder that has been equipped with a Type I
valve outlet as shown in Figure 3, and that is
1” in diameter and 18” in height. Always use
a propane cylinder that has been constructed
and marked in conformance with either the
specications for LP Gas Cylinders of the U.S.
Department of Transportation or the speci-
cations in the National Standard of Canada,
CAN/CSA-B339, Cylinder, Spheres and Tube
for Transportation of Dangerous Goods, as
applicable.
• Always conrm that your propane cylinder is equipped with a
shutoff valve terminating in a Type I propane cylinder valve outlet
connection, and that it has been provided with a collar to protect
the cylinder valve.
• Never install a propane cylinder in this Grill unless it is equipped
with a listed Overll Protection Device (OPD).
• Always have a new propane cylinder properly purged of air by
your certied propane gas dealer. Since a new cylinder is initially
lled with air, the air must rst be purged before it is lled with
propane.
• Always visually inspect the gas supply line for fraying, cracking
or rodent damage before each use of this Grill and, if necessary,
install a replacement hose and regulator obtained from the manu-
facturer prior to lighting this Grill.
• Always place a dust cap on the cylinder valve outlet whenever
the cylinder is not in use and always install the dust cap that was provided with the cylinder valve. The
use of an incorrect dust cap could result in leakage of propane.
"
,0TANK

Shutoff Valve
Collar
B15
Figure 3

"
HOSEREGULATOR

Check hose for breaks or
wear before each use.
Type 1 Connector
Regulator
B14
Figure 2
To Main Burner
Manifold
To Side
Burner Valve
(if equipped)
"
QUICKCONNECTHOSE

B3
Figure 2a
Type 1 Connector
Check hose for breaks or wear
before each use.
Regulator
To Main Burner
Manifold
Quick Connect for Reg-
ular Side Burner and
Optional Side Burner of
Built-in Models