Operating instructions

22
20304166
VCFDVI31 Gas Fireplace Insert
A/C Module
Control Board
RF Receiver
ON/OFF Button
Pilot
Black / Thermopile
Red / Thermopile
Sensor
Ignitor / Sparker
Conversion
NG/LP
Plug-in Connector
Control Board to Command Center
OFF/LO
LED
ON/HI
Master Switch
Command Center
Plug-in Connector
Stepper Motor to
Control Board
DC Power/Green
Ground
Plug-in Connector
Control Board to
Solenoid
Gas In
Gas Out
Pilot Gas Tubing
Valve
A/C Module
FP2962
SCS wiring diagram
To Outlet
Optional Aux.
300 Watts
Max
300 Watts
Max
300 Watts


This insert will work without any electrical supply.
Electricity is only needed to operate blower.
Verify proper operation after servicing.


  


    National Electrical Code ANSI/NFPA 70 (latest
edition)Canadian Electrical Code, CSA C22.1

   
 

   



Figure 31 -
Signature Command Wiring Diagram
 Wall switch
wires must be con-
nected together.