Specifications

TM036 Vermont Gas Fireplace & Gas Log Fire Service Instructions REV: A
D.O.I: 17/01/2008
This document is stored and maintained electronically by Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”
38
Burner – LHEC30 (Procedure 9)
1. Isolate power and gas supplies to the log fire.
2. Remove front glass assembly (refer to procedure 1).
3. Remove log assembly and larva rock from burner (reverse procedure 2).
4. Remove two screws retaining log bracket to log fire rear and remove log bracket.
5. Remove screw retaining burner manifold cover and remove burner manifold cover.
6. Remove two screws retaining burner hold down brackets to burner base.
7. Remove screw retaining pilot heat shield to pilot assembly and remove pilot heat
shield.
8. Withdraw burner by lifting burner up at right hand side to clear pilot assembly and then
sliding towards pilot assembly. Note: burner injectors may catch on burner hindering
withdrawal and necessitating some jiggling of burner to remove.
9. Complete reassembly in reverse order of above.
10. Test for gas leaks at all unions using soapy water solution.
Burner Injectors – LHEC30 (Procedure 10)
1. Remove burner (refer to procedure 9).
2. Unscrew and remove front and/or rear burner injector(s).
3. Complete reassembly in reverse order of above using gas sealing paste on burner
injector threads.
Burner Feed Pipe – LHEC30 (Procedure 11)
1. Remove the sheet metal base (refer to procedure 3).
2. Unscrew burner feed pipe nut at gas valve and remove burner feed pipe from gas
valve.
3. Unscrew burner feed pipe nut at burner manifold and remove burner feed pipe from
burner manifold.
4. Complete reassembly in reverse order of above.
5. Test for gas leaks at all unions using soapy water solution.
Burner Manifold – LHEC30 (Procedure 12)
1. Remove burner (refer to procedure 3).
2. Remove screw retaining burner manifold bracket to log fire base.
3. Unscrew nut retaining burner feed pipe to burner manifold and remove burner
manifold.
4. Unscrew and remove front and/or rear burner injector(s).
5. Unscrew and remove burner manifold to burner feed pipe adapter.
6. Complete reassembly in reverse order of above using gas sealing paste on burner
injector threads and burner manifold to burner feed pipe adapter.