Specifications

TM036 Vermont Gas Fireplace & Gas Log Fire Service Instructions REV: A

D.O.I: 17/01/2008

This document is stored and maintained electronically by Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”

If the set point temperature is now higher than the room temperature the optimum flame

and fan levels will automatically be selected to reach or maintain the set point temperature.

These levels (of modulation) will depend upon the differential between the set point

temperature and the room temperature i.e. larger differential = higher flame and fan levels.

For example: If there is a differential of 2.5 degrees the controller may automatically

determined that a flame height of 6 and a fan speed of 6 is required. When the room

temperature has reached the set point temperature the controller may then automatically

determine that a flame height of 1 and fan speed of 1 is required to maintain this

temperature.

Fan Override: It should be noted that when in auto mode the fan speed will be the same

as, and will automatically rise and fall with the flame speed. If a lower or higher fan speed

is desired, the fan speed can be overridden by pressing and releasing the fan button and

then adjusting the fan speed manually using the up or down arrow buttons as previously

explained.

If the fan speed has been overridden in this manner „Auto‟ will be displayed next to the

flame icon and „Manual‟ will be displayed next to the fan icon.

To revert to the auto fan setting, cycle through to „Auto‟ by pressing and releasing the

mode button until „Auto‟ appears for the second time („Auto‟ will first appear when the

mode button is pressed and released however you must cycle past this until „Auto‟

appears again).

Off Mode

Press and release the „mode‟ button until „OFF‟ is displayed. After a two second delay from

the operation of any button the burner and fan will turn off and room temperature and

„OFF‟ will be displayed on the controller.

Other Functions

Temperature Unit of Measurement: The temperature unit of measurement can be

changed from ºC to ºF and vice versa. To do this press and hold down the up and down

arrow buttons simultaneously until the display value changes (approximately three

seconds). This function may be performed whist the remote controller is in any mode.

Countdown Timer: A countdown timer is available and can be activated when the remote

control is in the „ON‟ (Manual) or „AUTO‟ mode. The countdown timer can be set from 10

minutes to 2 hours and will turn the burner and fan off when it reaches zero.

To activate the countdown timer first ensure the remote is in „ON‟ or „AUTO‟ mode then

press and release the timer button.

The timer time can then be adjusted up or down in ten minute increments by pushing and

releasing the up or down arrow buttons. After a 2 second delay the time will be accepted.

The display will then revert to the relevant setting (ON or AUTO) and the timer time will be

displayed along with the usual information.

When the countdown timer reaches zero the burner and fan will turn off and the remote

control will revert from „ON‟ or „AUTO‟ mode to „OFF” mode.

The countdown timer can be cancelled at any time after activation by pressing and

releasing the countdown timer button until -:-- is shown on the display. After a two second

delay the display will revert to the previously used setting and the delay timer will be

cancelled.